Lenze E82xVxxxKxxxxx - Manual (Page 172)

Extensions for automation
Standard devices in a power range from 3 ... 11 kW
I/O function modules
7
l
172 EDS82EV903 EN 3.0
7.2 Standard devices in a power range from 3 ... 11 kW
The frequency inverters are equipped with two module slots on the front of the housing:
ƒ The lower slot (FIF interface) serves to connect an I/O or bus function module.
– An I/O function module (standard I/O or application I/O) expands the controller by
control terminals for analog or digital inputs/outputs.
– Via a bus function module (e.g. PROFIBUS−DP PT or CAN PT) you connect the
controller to a fieldbus.
– A bus function module with control terminals (e.g. PROFIBUS−I/O, CAN−IO PT) is a
combination of the above−mentioned function modules.
ƒ You can connect a keypad or a communication module to the upper slot (AIF
interface).
– Via the keypad you parameterise the controller according to its application, read
out its status and diagnose errors.
– Via a communication module you connect the controller to a PC or to a fieldbus.
7.2.1 I/O function modules
Possible modules Type Comment
Standard I/O PT E82ZAFSC010 1 analog input (switchable between master
current/voltage)
1 analog output (voltage)
4 digital inputs
1 digital output
Application I/O PT E82ZAFAC010 2 analog inputs (switchable between master
current/voltage)
2 analog outputs (voltage or current)
6 digital inputs
2 digital outputs
1 frequency output
)
Note!
Information about the wiring and application is provided later on in this
chapter:
Standard I/O (
¶ 190)
Application I/O (
¶ 196)