Lenze E82xVxxxKxxxxx - Manual (Page 311)

Function library
Configuration of analog and digital setpoints and actual values
Setpoints via keypad
10
l
311 EDS82EV903 EN 3.0
10.7.6 Setpoints via keypad
Description
The setpoint can be selected via the keypad.
The keypad setpoint is added to the main setpoint.
)
Note!
ƒ Setpoints selected by means of the keypad are stored when the controller is
disconnected from the mains or operation is interrupted.
ƒ The drive can start again after controller enable!
Codes for parameter setting
Code Possible settings IMPORTANT
No. Name Lenze Selection
C0044
* Setpoint 2
(NSET1-N2) −650.00 {0.02
Hz}
650.00 The set value will be lost during
mains switching!
l Selection if C0412/2 =
FIXED−FREE (not assigned)
l Display if C0412/2 is linked to
a signal source
^ 311
C0046
* Setpoint 1
(NSET1-N1) −650.00 {0.02
Hz}
650.00 The set value will be lost during
mains switching!
l Selection if C0412/1 =
FIXED−FREE (not assigned)
l Display if C0412/1 is linked to
a signal source
^ 311
C0140
* Additive
frequency
setpoint
(NSET1−NADD) 0.00 −650.00 {0.02
Hz}
650.00 l Selection via j function of
the keypad or parameter
channel
l Acts additively on the main
setpoint
l Value will be stored when
switching the mains or
removing the keypad
l C0140 is only transferred
during parameter set transfer
with GDC (not with keypad)
^ 311
Select setpoint with E82ZBC keypad
You can simply select the setpoint by using the
j function:
1. Use
w or x to select the j function.
2. Set setpoint with
y or z.
– If the controller is enabled, the changed setpoint has a direct effect on the drive.
– If the controller is inhibited, the setpoint is saved. After the controller has been
enabled, the drive accelerates to the setpoint set last with the adjusted
acceleration or deceleration time.
)
Note!
j writes the setpoint into C0140. You can directly select the setpoint in
C0140.