Lenze E82xVxxxKxxxxx - Manual (Page 375)

Function library
Networking
Interconnection with function module system bus (CAN) E82ZAFCCxxx
10
l
375 EDS82EV903 EN 3.0
10.18 Networking
For networking with bus systems the controller has two interfaces:
ƒ the automation interface (AIF) for communication modules
ƒ the function interface (FIF) for function modules
A detailed description for networking with different bus system can be found in the
corresponding communication manuals.
10.18.1 Interconnection with function module system bus (CAN) E82ZAFCCxxx
Description
Codes which are required for the configuration of a system bus network with an
E82ZAFCCxxx function module are integrated in the controller.
A detailed description can be found in the CAN communication manual.
Codes for parameter setting
Code Possible settings IMPORTANT
No. Name Lenze Selection
C0350
*
v
System bus
node address 1 1 {1} 63 l Only for system bus function
module E82ZAFCC on the FIF
interface.
l Change becomes effective after
"Reset−Node" command
Set the node address in C0009 for
operation with communication
modules 217x.
^ 375
C0351
*
v
System bus
baud rate 0 0 500 kbps l Only for system bus function
module E82ZAFCC on the FIF
interface.
l Change becomes effective after
"Reset−Node" command
Set the baud rate in C0125 for
operation with communication
modules 217x.
^ 375
1 250 kbps
2 125 kbps
3 50 kbps
4 1000 kbps (function module
E82ZAFCC100 only)
5 20 kbps
C0352
*
v
Configuration
of system bus
node 0 0 Slave l Only for system bus function
module E82ZAFCC on the FIF
interface.
l Change becomes effective after
"Reset−Node" command
^ 375
1 Master
C0353
*
v
System bus
address source l Only for system bus function
module E82ZAFCC on the FIF
interface.
l Source of address for system
bus process data channels
^ 375
1 CAN1 (Sync) 0 0 C0350 is the source Effective with sync control (C0360
= 1)
2 CAN2 0 1 C0354 is the source
3 CAN1 (time) 0 Effective with event or time
control (C0360 = 0)