4 changing and saving parameters, Changing and saving parameters, Parameter setting – Lenze E82xVxxxKxxxxx User Manual
Page 239
Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
l
239
EDS82EV903 EN 3.0
9.3.4
Changing and saving parameters
)
Note!
Your menu settings are always saved to parameter set 1.
Two menus can be used for saving settings to parameter sets 2, 3 or 4:
ƒ
The "Code list" in menu 2 provides direct access to all available codes.
ƒ
The "Param managm" in menu 7 serves to copy parameter set 1 to other
parameter sets.
– Please observe that your "own basic setting" will be overwritten with the
settings of parameter set 1 during the copy process!
Step
Key seq.
Action
1.
Select menu
z y Z Y
Use the arrow keys to select the desired menu
2.
Change to the code level
Z
Display of the first code in the menu
3.
Select code or subcode
y z
Display of the current parameter value
4.
Change to the parameter level
V
5.
When SHPRG is displayed, inhibit the
controller
S
The drive coasts
6.
Change parameters
A
Z Y
Move cursor below the figure to be changed
B
y z
Change of figure
T y
T z
Quick change of figure
7.
Accept the changed parameter
Display of SHPRG or SHPRG
p
T V
Confirm change to accept the parameter
Display "OK"
Display
p −
The parameter has been accepted immediately
8.
Enable the controller, if required
U
The drive operates again
9.
Change to the code level
A
V
Display of the operating level
B
V
Display of the code with changes parameter
10. Change further parameters
Restart the "loop" with step 1. or 3.