Lenze E82xVxxxKxxxxx - Manual (Page 179)

Extensions for automation
Standard devices in a power range from 15 ... 90 kW
7
l
179 EDS82EV903 EN 3.0
7.3 Standard devices in a power range from 15 ... 90 kW
The frequency inverters are provided with 3 slots at the housing front:
ƒ The two lower slots (FIF I and FIF II interface) serve to connect an I/O module or a bus
function module.
– An I/O function module (standard I/O or application I/O) expands the controller by
control terminals for analog or digital inputs/outputs.
– Via a bus function module (e.g. PROFIBUS−DP PT or CAN PT) you connect the
controller to a fieldbus.
– A bus function module with control terminals (e.g. PROFIBUS−I/O, CAN−IO PT) is a
combination of the above−mentioned function modules.
ƒ You can connect an operating module or a communication module to the upper slot
(AIF interface).
– Via the operating module you parameterise the controller according to its
application, read out its status and diagnose errors.
– Via a communication module you connect the controller to a PC or to a fieldbus.
{
Danger!
ƒ The pins of the FIF interface have a basic insulation (single−insulating
distance).
ƒ Protection against contact − in the event of a defective insulating distance −
can only be ensured by external measures, e.g. double insulation.
Which function modules can be used?
8200 vector with one function
module Possible function modules on FIF I Standard I/O PT E82ZAFSC010
Application I/O PT E82ZAFAC010
PROFIBUS−DP E82ZAFPC010
PROFIBUS I/O E82ZAFPC201
CAN PT E82ZAFCC010
CAN−I/O PT E82ZAFCC210
CAN−I/O RS PT E82ZAFCC100
CANopen PT E82ZAFUC010
DeviceNet PT E82ZAFVC010
INTERBUS PT E82ZAFIC010
LECOM−B PT E82ZAFLC010
AS interface PT E82ZAFFC010
8200 vector with two function
modules Possible function modules on FIF I PROFIBUS−DP E82ZAFPC010
PROFIBUS−I/O 1) E82ZAFPC201
CAN PT E82ZAFCC010
CANopen PT E82ZAFUC010
DeviceNet PT E82ZAFVC010
INTERBUS PT E82ZAFIC010
LECOM−B PT E82ZAFLC010
Possible function modules on FIF II Standard I/O PT E82ZAFSC010
AS interface PT E82ZAFFC010
1) Digital inputs do not have any function. Use the digital inputs of the function module on FIF II instead