Parameter setting – Lenze E82xVxxxKxxxxx User Manual
Page 233
Parameter setting
Parameter setting with E82ZBC keypad
Remote parameter setting for system bus participants
l
233
EDS82EV903 EN 3.0
9.2.7
Remote parameter setting for system bus participants
If controllers are linked via the system bus (CAN), remote parameterisation of all other
nodes of the system bus is possible from a central point in the network.
For this purpose, use the
n function.
)
Note!
Instead of using the
nfunction, the system bus node can also be selected via
C0370.
Step
Key seq.
Result
Action
1.
Select function
t
Change to function bar 2
2.
wx
n
3.
Select node
address
yz
1 ... 63
Select node address
4.
t
r
Confirm address and change to function bar 1
Now remote parameterisation can be carried out for the node.
5.
Set
parameters
All settings are redirected to the selected node.
6.
Carry out
remote
parameterisati
on for more
system bus
nodes if
required
Restart the process with step 1.
Do not forget to switch off remote parameterisation after completion of your settings:
7.
Switch off
remote
parameterisati
on
t
Change to function bar 2
8.
wx
n
9.
y
0
Switch off remote parameterisation
10.
t
Confirm and change to function bar 1
Remote parameterisation is completed.