Lenze E82xVxxxKxxxxx - Manual (Page 250)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Menu structure
9
l
250 EDS82EV903 EN 3.0
Description Submenus Main menu Description
Display No. Display No.
5.26 PID−Ctrl 5 Operation with the system bus (CAN) function module on FIF
Setpoint via process data channel (CAN−IN1.W2)
Actual value via process data channel (CAN−IN1.W3)
5.26.1 CAN managem System bus (CAN) communication set−up
5.26.2 Setpoint Setpoint configuration
5.26.3 Actual value Actual value configuration
5.26.4 PCTRL setup Process controller configuration
5.26.5 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.26.6 Motor param Motor current control configuration, motor monitoring
5.27 PID−Ctrl 7 Operation with fieldbus function module on FIF (DRIVECOM
control)
Frequency setpoint via process data channel
Actual frequency value via process data channel
5.27.1 FIF managem Fieldbus communication set−up
5.27.2 Setpoint Setpoint configuration
5.27.3 Actual value Actual value configuration
5.27.4 PCTRL setup Process controller configuration
5.27.5 f limit/ramp Output frequency, acceleration time and deceleration time
configuration
5.27.6 Motor param Motor current control configuration, motor monitoring
6 Diagnostics Diagnostics
6.1 Fault history Fault analysis with history buffer
6.2 Status words Display of status words
6.3 Monit drive Display codes to monitor the drive
6.4 Monit FIF Display codes for monitoring a fieldbus function module
7 Param
managm Parameter set management
7.1 Load / Store Parameter set transfer, restore delivery status
7.2 Copy PAR1 −>2 Copy parameter set 1 to parameter set 2
7.3 Copy PAR1 −>3 Copy parameter set 1 to parameter set 3
7.4 Copy PAR1 −>4 Copy parameter set 1 to parameter set 4
8 Main FB Configuration of function blocks
8.1 Cfg NSET1 Setpoint processing
8.2 Cfg PCTRL1 Process controller
8.3 Cfg DCTRL1 Internal control
8.4 Cfg MCTRL1 Motor control
9 Controller Configuration of internal control parameters
9.1 V/f−Ctrl V/f characteristic control
9.2 Vector−Ctrl Vector control
9.3 PCTRL setpt Process controller setpoints
9.4 PCTRL act val Actual process controller values
9.5 PCTRL setup Process control
9.6 Current setup Current limits and current controllers
9.7 Setpt setup Setpoints
9.8 Ramp times Acceleration times, deceleration times
9.9 DCB (DC brk) DC injection brake
9.10 Fault monit Fault monitoring, fault display