Lenze E82xVxxxKxxxxx - Manual (Page 380)

Function library
Code table
10
l
380 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0002
*
s
uSEr
Parameter set
management 0 0 Ready PAR1 ... PAR4:
l Parameter sets of the
controller
l PAR1 ... PAR4 also contain the
parameters for the function
modules standard I/O,
application I/O, AS interface,
system bus (CAN)
FPAR1:
l Module−specific parameter set
of the fieldbus function
modules INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
l FPAR1 is saved in the function
module
^ 368
Restoring the
delivery status 1 Lenze setting ð PAR1 Restore the delivery status in the
parameter set selected
2 Lenze setting ð PAR2
3 Lenze setting ð PAR3
4 Lenze setting ð PAR4
31 Lenze setting ð FPAR1 Restore the delivery status in the
fieldbus function module
61 Lenze setting ð PAR1 + FPAR1 Restore the delivery status in the
selected parameter set of the
controller and in the fieldbus
function module
62 Lenze setting ð PAR2 + FPAR1
63 Lenze setting ð PAR3 + FPAR1
64 Lenze setting ð PAR4 + FPAR1
C0002
*
s
uSEr
(Cont.)
Transferring
parameter sets
with the
keypad By means of the keypad you can
transfer the parameter sets to
other controllers.
During the transmission the
access to the parameters via other
channels is inhibited!
Keypad ð controller Overwrite all available parameter
sets (PAR1 ... PAR4, if required
FPAR1) with the corresponding
data of the keypad
70 with function module application I/O,
INTERBUS, PROFIBUS−DP, LECOM−B,
DeviceNet, CANopen
10 with all other function modules