Lenze E82xVxxxKxxxxx - Manual (Page 394)

Function library
Code table
10
l
394 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0125
*
v
Baud rate 0 LECOM System
bus (CAN) 217x Only for communication modules
on the AIF interface:
l LECOM−A (RS232) E82ZBL
l LECOM−A/B/LI 2102
l System bus (CAN) 217x
Set the baud rate for operation
with system bus function module
E82ZAFCC in C0351.
0 9600 baud 500 kbaud
1 4800 baud 250 kbaud
2 2400 baud 125 kbaud
3 1200 baud 50 kbaud
4 19200 baud 1000 kbaud
C0126
*
v
Behaviour with
communicatio
n error 10 Monitored communication channel A combination of monitorings is
activated by entering the sum of
the selection values
0 All monitoring deactivated
1 Process data channel of AIF interface Communication interrupt with
active monitoring trips TRIP CE0
2 Internal communication between
function module on FIF and drive
controller Communication interrupt with
active monitoring trips TRIP CE5
4 Communication (Bus OFF) for
operation with function module
system bus (CAN) on FIF Communication interrupt with
active monitoring trips TRIP CE6
8 Remote parameterisation C0370 for
operation with function module
system bus (CAN) on FIF Communication interrupt with
active monitoring trips TRIP CE7
C0127
v
Setpoint
selection 0 0 Setpoint selection in absolute values in
Hz via C0046 or process data channel
(
±24000 º480 Hz)
1 Scaled setpoint selection via C0141 (0
... 100 %) or process data channel
(
±16384 = C0011)
C0128 Service code Alterations by Lenze service only!