Lenze E82xVxxxKxxxxx - Manual (Page 402)

Function library
Code table
10
l
402 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0225
(A) Acceleration
time − process
controller
setpoint
(PCTRL1−SET1) 0.00 0.00 {0.02 s} 1300.00 Ramp function generator for
process controller setpoint =
PCTRL1−RFG2
C0226
(A) Deceleration
time − process
controller
setpoint
(PCTRL1−SET1) 0.00 0.00 {0.02 s} 1300.00
C0228
(A) Fade−in time −
process
controller 0.000 0.000 {0.001 s} 32.000 0.000 = process controller output
information is communicated
without being displayed
C0229
(A) Fade−out time −
process
controller 0.000 0.000 {0.001 s} 32.000 0.000 = fade−out switched off
(C0241)
C0230
(A) Lower limit for
process
controller
output −100.0 −200.0 {0.1 %} 200.0 Asymmetrical limitation of the
process controller output, based
on C0011
l If the value falls below C0230
or exceeds C0231:
– Output signal PCTRL1−LIM =
HIGH after expiration of the
time set in C0233
l Set C0231 > C0230
C0231
(A) Upper limit for
process
controller
output 100.0 −200.0 {0.1 %} 200.0
C0232
(A) Offset for
inverse
characteristic
of process
controller 0.00 −200.0 {0.1 %} 200.0 Based on C0011
C0233
*
(A) Deceleration
PCTRL1−LIM=
HIGH 0.000 0.000 {0.001 s} 65.000 "Debouncing" of digital output
signal PCTRL1−LIM (limits for
process controller output
exceeded)
l Sets PCTRL1−LIM = HIGH if the
following still holds true after
expiration of the set time:
– Value fallen below C0230 or
exceeded C0231
l Transition HIGH ð LOW
without deceleration
C0234
*
(A) Deceleration
PCTRL1−SET=
ACT 0.000 0.000 {0.001 s} 65.000 "Debouncing" of digital output
signal PCTRL1−SET=ACT (process
controller setpoint = actual
process controller value)
l Sets PCTRL1−SET=ACT = HIGH if
the following still holds true
after expiration of the set time:
– Difference between
PCTRL1−SET and PCTRL1−ACT
is within operating threshold
C0235
l Transition HIGH ð LOW
without deceleration