Lenze E82xVxxxKxxxxx - Manual (Page 200)

Extensions for automation
I/O function module E82ZAFACO10 (application I/O PT)
Installation
7
l
200 EDS82EV903 EN 3.0
X3.1/ Signal type Function Level
(Lenze setting: bold print)
1U/2U Analog
inputs Actual value or setpoint inputs (master voltage)
Change range with jumper and C0034 0 ... +5 V
0 ... +10 V
−10 V ... +10 V
1I/2I Actual value or setpoint inputs (master current)
Change range with jumper and C0034 0 ... +20 mA
+4 ... +20 mA
+4 ... +20 mA (open−circuit
monitored)
X3.2/ Signal type Function Level
(Lenze setting: bold print)
62 Analog
outputs Output frequency Voltage output:
0 ... +6 V
0 ... +10 V
1)
Current ouput:
(0 ... +12 mA)
0 ... +20 mA
1)
+4 ... +20 mA 1)
63 Motor current
9 − Internal, stabilised DC voltage source for setpoint
potentiometer +5.2 V
1) Output level 0 ... + 10 V or 0/+4 ... +20 mA: adapt offset (C0422) and gain (C0420).
X3.3/ Signal type Function Level
(Lenze setting: bold print)
A1 Digital
outputs Ready for operation
0/+20 V at DC internal
0/+24 V at DC external
A2 Not preconfigured
7 − GND, reference potential −
A4 Frequency
output DC−bus voltage HIGH:
+18 V ... +24 V (HTL)
LOW: 0 V
59 − DC supply for X3/A1 and X3/A2 +20 V (internal, bridge to X3/20)
+24 V (external)
20 − Internal DC voltage source for control of the
digital inputs and outputs +20 V ± 10 %
28
Digital
inputs
Controller inhibit (CINH) 1 = START
E1 1) Activation of fixed frequencies (JOG)
JOG1 = 20 Hz
JOG2 = 30 Hz
JOG3 = 40 Hz E1 E2
JOG1 1 0
E2 1) JOG2 0 1
JOG3 1 1
E3 DC injection brake (DCB) 1 = DCB
E4 Reversal of rotation direction
CW rotation/CCW rotation (CW/CCW) E4
CW 0
CCW 1
E5 Not preconfigured −
E6 Not preconfigured −
1) Optionally frequency input 0 ... 102.4 kHz, one or two−track, configuration via C0425