Lenze E82xVxxxKxxxxx - Manual (Page 352)

Function library
Free interconnection of digital signals
Free configuration of digital outputs
10
l
352 EDS82EV903 EN 3.0
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0423
*
(A) Delay of digital
outputs 0.000 {0.001 s} 65.000 "Debouncing" of the digital
outputs
(from version: application I/O
E82ZAFA ... Vx11)
l Switches the digital output if
the linked signal is still active
after the time set.
l The digital output is reset
without delay
^ 348
1 Device version
151:
relay output K1
(RELAY)
Device version
152, 153:
Digital
switching
output K1
0.000
2 Digital output
X3/A1
(DIGOUT1)
0.000
3 Digital output
X3/A2
(DIGOUT2)
0.000
Linking signals
The digital outputs are linked to internal digital signals by entering the selection number
of the internal signal into the corresponding subcode of C0415. C0415 may have different
values in the parameter sets.
Examples
ƒ C0415/2 ð15: signal source for X3/A1 is the "CCW rotation" status message
ƒ C0415/1
ð60: signal source for K1 is the status of bit 1 of process data word
CAN−IN1/Word 1
)
Note!
Process data input words CAN−IN1.W1/FIF−IN.W1, CAN−IN1.W2/FIF−IN.W2,
CAN−IN2.W1 and CAN−IN2.W2 can be defined as analog words or as digital
words (16 bits). When being linked to digital outputs (C0415/x = 60 ... 135),
they must be defined as digital input words. Otherwise the output signal will
not be correct.
Signal level for V−belt monitoring
Please observe the way the signals are generated for V−belt monitoring by means of the
current threshold C0156 (monitoring signals 20, 21, 22):
ƒ The display value (C0054) is smoothed with a ring buffer with 500 ms.
ƒ The value set in C0156 in percent corresponds to the rated device current I
rated
.
ƒ In the V/f characteristic control with quadratic characteristic" operating mode
(C0014 = 3), device−internal adjustment of C0156 is carried out via the output
frequency:
C0156
int
[%] + C0156 [%] @
f 2 [Hz 2 ]
C0011 2 [Hz 2 ]