Syntax, Default configuration, Command mode – Dell POWEREDGE M1000E User Manual
Page 1011: User guidelines, Example
IPv6 Routing Commands
1011
Syntax
traceroute ipv6 {
ip-address
|
hostname
}
[
port
]
•
ipv6-address
— Destination IPv6 address.
•
hostname
— Hostname to ping (contact). (Range: 1–158 characters). The
command allows spaces in the host name when specified in double quotes.
For example,
console(config)#traceroute "host name"
•
port
— UDP port used as the destination of packets sent as part of the
traceroute. This port should be an unused port on the destination system.
(Range: 0–65535)
Default Configuration
33434 is the default port value.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example discovers the packet routes on a hop-by-hop basis.
console#traceroute ipv6 2020:1::1
Tracing route over a maximum of 20 hops
1 * N * N * N
2CSPC4.XModular-SWUM200.book Page 1011 Thursday, March 10, 2011 11:18 AM