Dell POWEREDGE M1000E - Manual (Page 1025)

Multicast Commands 1025
no ip pim dense
Default Configuration
PIM is not enabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router.
Example
console(config)#ip pim dense
ip pim dr-priority
The ip pim dr-priority command in Interface (VLAN) Configuration mode
to administratively configure the advertised designated router (DR) priority
value. Use the no form of this command to return the configuration to the
default.
Syntax
ip pim dr-priority priority
no ip pim dr-priority
• priority — The administratively configured priority (Range:
0–2147483647).
Default Configuration
The default election priority is 1.
Command Mode
Interface (VLAN) Configuration mode
2CSPC4.XModular-SWUM200.book Page 1025 Thursday, March 10, 2011 11:18 AM