Dell POWEREDGE M1000E - Manual (Page 152)

152 Command Groups
sFlow
debug mldsnooping Traces MLD snooping packet reception and
transmission.
PE
debug ospf Enables tracing of OSPF packets received and
transmitted by the switch.
PE
debug ospfv3 Enables tracing of OSPFv3 packets received and
transmitted by the switch.
PE
debug ping Enables tracing of ICMP echo requests and
responses.
PE
debug rip Enables tracing of RIP requests and responses. PE
debug sflow Enables sFlow debug packet trace. PE
debug spanning-tree Traces spanning tree BPDU packet reception
and transmission.
PE
debug vrrp Enables VRRP debug protocol messages. PE
show debugging Displays packet tracing configurations. PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
Command Description Mode a
sflow destination Configures sFlow collector parameters (owner
string, receiver timeout, ip address, and port).
GC
sflow polling Enables a new sflow poller instance for the data
source if rcvr_idx is valid.
GC
sflow polling (Interface
Mode)
Enable a new sflow poller instance for this data
source if rcvr_idx is valid.
IC
sflow sampling Enables a new sflow sampler instance for this
data source if rcvr_idx is valid.
GC
sflow sampling (Interface
Mode)
Enables a new sflow sampler instance for this
data source if rcvr_idx is valid.
IC
show sflow agent Displays the sflow agent information. PE
show sflow destination Displays all the configuration information
related to the sFlow receivers.
PE
Command Description Mode a
2CSPC4.XModular-SWUM200.book Page 152 Thursday, March 10, 2011 11:18 AM