Dell POWEREDGE M1000E - Manual (Page 662)

662 RADIUS Commands
Command Mode
Global Configuration mode
User Guidelines
If only one RADIUS server is configured, it is recommended that the
deadtime interval be left at 0.
Example
The following example sets the minimum interval for a RADIUS server will
not be contacted after becoming unresponsive.
console(config)#radius-server deadtime 10
radius-server host
Use the radius-server host command in Global Configuration mode to specify
a RADIUS server host and enter RADIUS Configuration mode. To delete the
specified Radius host, use the no form of this command.
Syntax
radius-server host [ acct | auth ] { ip–address | hostname }
no radius-server host [ acct | auth ] { ip–address | hostname }
Parameter Description
Default Configuration
The default server type is authentication. The default server name is Default
RADIUS Server. The default port number is 1812 for an authentication
server and 1813 for an accounting server.
Parameter Description
acct | auth The type of server (accounting or authentication).
ip–address The RADIUS server host IP address.
hostname Host name of the Radius server host. (Range: 1–255
characters).
2CSPC4.XModular-SWUM200.book Page 662 Thursday, March 10, 2011 11:18 AM