Dell POWEREDGE M1000E - Manual (Page 1166)

1166 OSPFv3 Commands
User Guidelines
This command has no user guidelines.
Example
The following example defines the OSPF area to which VLAN 15 belongs.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf area 100
ipv6 ospf cost
Use the ipv6 ospf cost command in Interface Configuration mode to
configure the cost on an OSPF interface. Use the no form of the command to
return the cost to the default value.
Syntax
ipv6 ospf cost interface-cost
no ipv6 ospf cost
• inte rface-cost — Specifies the cost (link-state metric) of the OSPF
interface. (Range: 1–65535)
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a cost of 100.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf cost 100
2CSPC4.XModular-SWUM200.book Page 1166 Thursday, March 10, 2011 11:18 AM