Dell POWEREDGE M1000E - Manual (Page 1026)

1026 Multicast Commands
User Guidelines
This command only has an effect if sparse mode is enabled. Lower values are
preferred.
Example
console(if-vlan10)#ip pim dr-priority 32768
ip pim hello-interval
The ip pim hello-interval command in Interface (VLAN) Configuration
mode to administratively configure the frequency of PIM Hello messages on
the specified interface. Use the no form of this command to return the
configuration to the default. This command deprecates the ip pimsm query-
interval, the ip pimsm hello-interval and the ip pimdm hello-interval
commands.
Syntax
ip pim hello-interval interval
no ip pim hello-interval
• interval — The number of seconds between successive hello transmissions.
Range: 0–18000 seconds. Default is 30.
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip pim hello-interval 20
2CSPC4.XModular-SWUM200.book Page 1026 Thursday, March 10, 2011 11:18 AM