Syntax, Default configuration, Command mode – Dell POWEREDGE M1000E User Manual
Page 376: User guidelines, Example, Interface range
376
Ethernet Configuration Commands
NOTE:
Additional forms of the interface command enable configuring VLANs,
tunnels, the loopback interface, the out-of-band interface, and ranges of interfaces.
See interface vlan, interface tunnel, interface loopback, and interface range.
Syntax
interface {gigabitethernet
unit/slot/port
| port-channel
port-channel-number
| tengigabitethernet
unit/slot/port
}
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
Interface Configuration
User Guidelines
It is possible to enter interface configuration mode from global configuration
mode or from interface configuration mode.
Example
The following example enables gigabit port 2 on stack member 1 for
configuration.
console(config)# interface gigabitethernet 1/0/2
console (config-if)#
interface range
Use the interface range command in Global Configuration mode to execute a
command on multiple ports at the same time.
NOTE:
An additional form of this command enables configuring a range of VLANs.
Syntax
interface range {
port-rang
e |
port-type
all}
2CSPC4.XModular-SWUM200.book Page 376 Thursday, March 10, 2011 11:18 AM