Mvr group, Syntax, Parameter description – Dell POWEREDGE M1000E User Manual
Page 551: Default configuration, Command mode, User guidelines, Example
Multicast VLAN Registration Commands
551
mvr group
Use the mvr group command in Global Config mode to add an MVR
membership group. Use the no form of the command to remove an MVR
membership group.
Syntax
mvr group
A.B.C.D
[
count
]
no mvr group
A.B.C.D
[
count
]
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
Global Config
User Guidelines
The following table lists the completion messages.
Example
console(config)#mvr
Parameter
Description
A.B.C.D
Specify a multicast group.
count
Specifies the number of multicast groups to configure. Groups
are configured contiguously by incrementing the first group
specified.
Message Type
Message Description
Successful Completion Message
None
Error Completion Message
• Not an IP multicast group address
• Illegal IP multicast group address
2CSPC4.XModular-SWUM200.book Page 551 Thursday, March 10, 2011 11:18 AM