Dell POWEREDGE M1000E - Manual (Page 1078)

1078 OSPF Commands
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Examples
The following examples define area 3 for the stub and then removes the stub
area.
console(config-router)#area 3 stub
console(config-router)#no area 3 stub
area stub no-summary
Use the area stub no-summary command in Router OSPF Configuration
mode to prevent Summary LSAs from being advertised into the NSSA. Use
the no form of the command to return the Summary LSA mode to the
default value.
Syntax
area area-id stub no-summary
no area area-id stub no-summary
• area-id — Identifies the OSPF area to configure. (Range: IP address or
decimal from 0–4294967295)
Default Configuration
Disabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 1078 Thursday, March 10, 2011 11:18 AM