Syntax, Default configuration, Command mode – Dell POWEREDGE M1000E User Manual
Page 1243: User guidelines, Example, Vrrp preempt, Syntax description
Virtual Router Redundancy Protocol Commands
1243
Syntax
vrrp
vr-id
mode
no vrrp
vr-id
mode
•
vr-id
— The virtual router identifier. (Range: 1-255)
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the virtual router for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#vrrp 5 mode
vrrp preempt
Use the vrrp preempt command in Interface Configuration mode to set the
preemption mode value for the virtual router configured on a specified
interface. Use the no form of the command to disable preemption mode.
Syntax
vrrp
group
preempt [delay
seconds
]
no vrrp
group
preempt
Syntax Description
Parameter
Description
group
The virtual router identifier. (Range: 1-255)
2CSPC4.XModular-SWUM200.book Page 1243 Thursday, March 10, 2011 11:18 AM