Dell POWEREDGE M1000E - Manual (Page 537)

LLDP Commands 537
• interval — The smallest interval in seconds at which to send remote data
change notifications. (Range: 5–3600 seconds)
Default Configuration
The default value is 5 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to set the interval value to 10 seconds.
console(config)#lldp notification-interval 10
lldp receive
Use the lldp receive command in Interface Configuration mode to enable the
LLDP receive capability. To disable reception of LLDPDUs, use the no form
of this command.
Syntax
lldp receive
no lldp receive
Default Configuration
The default lldp receive mode is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 537 Thursday, March 10, 2011 11:18 AM