Dell POWEREDGE M1000E - Manual (Page 288)

288 Auto-VoIP Commands
--More-- or (q)uit
The following example shows command output when a port is specified:
console#show switchport voice gigabitethernet 1/0/1
Interface Auto VoIP Mode Traffic Class
--------- -------------- -------------
Gi1/0/1 Disabled 6
The command output provides the following information:
• AutoVoIP Mode—The Auto VoIP mode on the interface.
• Traffic Class—The Cos Queue or Traffic Class to which all VoIP traffic is
mapped. This is not configurable and defaults to the highest COS queue
available in the system for data traffic.
switchport voice detect auto
The switchport voice detect auto command is used to enable the VoIP Profile
on all the interfaces of the switch (global configuration mode) or for a specific
interface (interface configuration mode).Use the no form of the command to
disable the VoIP Profile.
Syntax
switchport voice detect auto
no switchport voice detect auto
Default Configuration
This feature is disabled by default.
2CSPC4.XModular-SWUM200.book Page 288 Thursday, March 10, 2011 11:18 AM