Dell POWEREDGE M1000E - Manual (Page 738)

738 VLAN Commands
The IP Subnet to VLAN association does not exist.
switchport access vlan
Use the switchport access vlan command in Interface Configuration mode to
configure the VLAN ID when the interface is in access mode. To reconfigure
the default, use the no form of this command.
Syntax
switchport access vlan vlan-id
no switchport access vlan
• vlan-id — A valid VLAN ID of the VLAN to which the port is configured.
Default Configuration
The default value for the vlan-id parameter is 1.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
The command automatically removes the port from the previous VLAN and
adds it to the new VLAN.
Example
The following example configures a VLAN ID of interface 1/0/8 to become an
access member of VLAN ID 23.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#switchport access vlan 23
2CSPC4.XModular-SWUM200.book Page 738 Thursday, March 10, 2011 11:18 AM