Dell POWEREDGE M1000E - Manual (Page 1118)

1118 OSPF Commands
LSA High Water
Mark
The maximum number of LSAs that have been in the link state
database since OSPF began operation.
Retransmit List
Entries
The current number of entries on all neighbors’ retransmit lists.
Maximum Number
of Retransmit
Entries
The maximum number of entries that can be on neighbors’
retransmit lists at any given time. This is the sum for all
neighbors. When OSPF receives an LSA and cannot allocate a
new retransmit list entry, the router does not acknowledge the
LSA, expecting the sender to retransmit.
Retransmit Entries
High Water Mark
The maximum number of retransmit list entries that have been
on all neighbors’ retransmit lists at one time.
NSF Support Whether graceful restart is administratively enabled. Possible
values are Support Always, Disabled, or Planned.
NSF Restart
Interval
The number of seconds a helpful neighbor allows a restarting
router to complete its graceful restart.
NSF Restart Status Whether the router is currently performing a graceful restart.
NSF Restart Age
The number of seconds until a graceful restart expires. Only
non-zero when the router is in graceful restart.
NSF Restart Exit
Reason
The reason the previous graceful restart ended. Possible values
are Not attempted, In progress, Completed, Timed out,
Topology change, and Manual clear.
NSF Helper
Support
Whether this router is configured to act as a graceful restart
helpful neighbor. Possible values are: Helper Support Always,
Disabled, or Planned.
NSF Helper Strict
LSA Checking
As a graceful restart helpful neighbor, whether to terminate the
helper relationship if a topology change occurs during a
neighbor's graceful restart.
Redistributing This field is a heading and appears only if you configure the
system to take routes learned from a non-OSPF source and
advertise them to its peers.
Source Shows source protocol/routes that are being redistributed.
Possible values are static, connected, or RIP.
Tag Shows the decimal value attached to each external route.
Subnets When this option is not configured, OSPF will only redistribute
classful prefixes.
2CSPC4.XModular-SWUM200.book Page 1118 Thursday, March 10, 2011 11:18 AM