Dell POWEREDGE M1000E - Manual (Page 1578)

1574 System Management Commands
Parameter Description Range Default
NSF
Administrative
Status
Whether nonstop forwarding is
administratively enabled or disabled
Enabled
Disabled
Enabled
NSF Operational
Status
Indicates whether NSF is enabled
on the stack.
Enabled
Disabled
None
Last Startup
Reason
The type of activation that caused
the software to start the last time.
There are four options. “Power-On”
means that the switch rebooted.
This could have been caused by a
power cycle or an administrative
“Reload” command. “Administrative
Move” means that the administrator
issued a command for the stand-by
manager to take over. “Warm-Auto-
Restart” means that the primary
management card restarted due to a
failure, and the system executed a
nonstop forwarding failover. “Cold-
Auto-Restart” means that the
system switched from the active
manager to the backup manager and
was unable to maintain user data
traffic. This is usually caused by
multiple failures occurring close
together.
Power-On
Administrative-
Move
Warm-Auto-
Restart
Cold-Auto-
Restart
None
Time Since Last
Restart
Time since the current management
card became the active management
card. For the backup manager, the
value is set to 0d 00:00:00
Time Stamp 0d
00:00:00
Restart in progress Whether a restart is in progress. A
restart is not considered complete
until all hardware tables have been
fully reconciled.
Yes or No
Warm Restart
Ready
Whether the initial full checkpoint
has finished
Yes or No
2CSPC4.XModular-SWUM200.book Page 1574 Thursday, March 10, 2011 11:18 AM