Dell POWEREDGE M1000E - Manual (Page 1468)

1464 Sflow Commands
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 polling gigabitethernet
1/0/1-10 200
sflow polling (Interface Mode)
Use the sflow polling command in Interface Mode to enable a new sflow
poller instance for this data source if rcvr_idx is valid. Use the "no" form of
this command to reset poller parameters to the defaults.
Syntax
sflow rcvr-index polling poll-interval
no sflow rcvr-index polling
• rcvr-index — The sFlow Receiver associated with the poller (Range: 1 - 8).
• poll-interval — The sFlow instance polling interval. A poll interval of 0
disables counter sampling. A value of n means once in n seconds a counter
sample is generated. (Range: 0 - 86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Interface Configuration (Ethernet) mode
2CSPC4.XModular-SWUM200.book Page 1464 Thursday, March 10, 2011 11:18 AM