Dell POWEREDGE M1000E - Manual (Page 967)

IPv6 Routing Commands 967
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-
interval 5000
ipv6 mld-proxy
Use the ipv6 mld-proxy command to enable MLD Proxy on the router. To
enable MLD Proxy on the router, you must also enable multicast forwarding.
Also, ensure that there are no other multicast routing protocols enabled on
the router. Use the “no” form of this command to disable MLD Proxy.
Syntax
ipv6 mld-proxy
no ipv6 mld-proxy
Default Configuration
MLD Proxy is disabled by default.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld-proxy
ipv6 mld-proxy reset-status
Use the ipv6 mld-proxy reset-status command to reset the host interface
status parameters of the MLD Proxy router. This command is only valid when
MLD Proxy is enabled on the interface.
2CSPC4.XModular-SWUM200.book Page 967 Thursday, March 10, 2011 11:18 AM