Dell POWEREDGE M1000E - Manual (Page 1024)

1024 Multicast Commands
Syntax
ip pim bsr-candidate vlan { vlan-id hash-mask-length bsr-priority }
no ip pim bsr-candidate vlan { vlan-id}
Parameter Description
Default Configuration
None - the router does not advertise itself as a BSR candidate.
Command Mode
Global Configuration mode
User Guidelines
All multicast groups with the same hash value correspond to the same RP.
Lower priority values are preferred.
Example
console(config)#ip pim bsr-candidate vlan 10 16 0
ip pim dense
Use the ip pim dense command in Global Configuration mode to
administratively configure PIM dense mode for IP multicast routing. Use the
no form of this command to disable PIM dense mode. This command
replaces the ip pimsm command.
Syntax
ip pim dense
Parameter Description
vlan-id A valid VLAN identifier with multicast routing enabled.
hash-mask-length Length of the BSR hash to be ANDed with the multicast
group address. (Range 0–32 bits). Default 0.
bsr-priority The advertised priority of the BSR candidate. Range 0-255.
Default 0.
2CSPC4.XModular-SWUM200.book Page 1024 Thursday, March 10, 2011 11:18 AM