Dell POWEREDGE M1000E - Manual (Page 974)

974 IPv6 Routing Commands
console(config-if-vlan15)#ipv6 nd managed-config-flag
ipv6 nd ns-interval
Use the ipv6 nd ns-interval command in Interface Configuration mode to set
the interval between router advertisements for advertised neighbor
solicitations. An advertised value of 0 means the interval is unspecified.
Syntax
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
• milliseconds — Interval duration. (Range: 0, 1000–4294967295)
Default Configuration
0 is the default value for milliseconds .
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval between router advertisements for
advertised neighbor solicitations at 5000 ms.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ns-interval 5000
ipv6 nd other-config-flag
Use the ipv6 nd other-config-flag command in Interface Configuration mode
to set the “other stateful configuration” flag in router advertisements sent
from the interface.
2CSPC4.XModular-SWUM200.book Page 974 Thursday, March 10, 2011 11:18 AM