Dell POWEREDGE M1000E - Manual (Page 889)

IGMP Proxy Commands 889
46
IGMP Proxy Commands
IGMP Proxy is used by the router on IPv4 systems to enable the system to
issue IGMP host messages on behalf of hosts that the system discovered
through standard IGMP router interfaces, thus acting as proxy to all its hosts
residing on its router interfaces.
PowerConnect supports IGMP Version 3, Version 2 and Version 1. Version 3
adds support for source filtering [SSM] and needs to be interoperable with
Versions 1 and 2. Version 2 supports the group membership terminations to
be quickly reported to overcome leave latency and is designed to be
interoperable with Version 1.
Commands in this Chapter
This chapter explains the following commands:
ip igmp-proxy
Use the ip igmp-proxy command in Interface Configuration mode to enable
the IGMP Proxy on the router. To enable the IGMP Proxy on the router,
multicast forwarding must be enabled and there must be no multicast routing
protocols enabled on the router.
Syntax
ip igmp-proxy
no ip igmp-proxy
ip igmp-proxy show ip igmp-proxy interface
ip igmp-proxy reset-status show ip igmp-proxy groups
ip igmp-proxy unsolicited-report-interval show ip igmp-proxy groups detail
show ip igmp-proxy
2CSPC4.XModular-SWUM200.book Page 889 Thursday, March 10, 2011 11:18 AM