Dell POWEREDGE M1000E - Manual (Page 1573)

System Management Commands 1569
Expected Code Type................ 0x100b000
Supported Cards:
Slot....................... 0
Card Index (CID)........... 3
Model Identifier............ PCM8024
console#
The following table describes the fields in the example.
show switch
NOTE: The show switch stack-port command in Stack Configuration mode is not
supported by the PCM8024 and PCM8024-k switches.
Use the show switch command in User EXEC mode to display information
about units in the stack.
The show switch command shows the configuration and status of the
stacking units, including the active and standby stack management units, the
pre-configured model identifier, the plugged in model identifier, the switch
status and the current code version. If there is a stack firmware
synchronization (SFS) operation in progress, the switch status will show as
Updating Code. Both the pre-configured switch type (as set by the member
command in stack mode) and the actual connected switch type are shown.
The show switch
unitid command shows details of the switch configuration
including the SFS last attempt status for the specified unit.
Field Description
Switch Type This field displays the 32-bit numeric
switch type for the supported switch.
Model Identifier This field displays the model identifier for
the supported switch type.
Switch Description This field displays the description for the
supported switch type.
2CSPC4.XModular-SWUM200.book Page 1569 Thursday, March 10, 2011 11:18 AM