Dell POWEREDGE M1000E - Manual (Page 1041)

Multicast Commands 1041
BSR Address............................. 192.168.10.1
BSR Priority............................ 0
BSR Hash Mask Length.................... 10
Next bootstrap message(hh:mm:ss)........ 00:00:11
Next Candidate RP advertisement(hh:mm:ss)00:00:02
If no configured/elected BSRs exist on the router, the following message is
displayed.
No BSR’s exist/learned on this router.
show ip pim interface
The show ip pim interface command displays the PIM interface status
parameters. If the interface number is not is specified, the command displays
the status parameters of all the PIM-enabled interfaces. This command
deprecates the show ip pimsm interface stats, show ip pimsm interface and
show ip pimdm interface commands.
Syntax
show ip pimsm interface [ vlan vlan-id ]
• vlan-id — A valid VLAN ID for which multicast routing has been enabled.
Field Descriptions
Field Description
Mode Active PIM Protocol
Interface Interface number
Hello Interval Hello interval value
Join-prune Interval Join-prune interval value
DR Priority
DR Priority configured on this interface
BSR Border Whether or not this interface is configured as a BSR Border
Neighbor Count Number of PIM Neighbors learnt on this interface
Designated-Router IP address of the elected DR on the interface
2CSPC4.XModular-SWUM200.book Page 1041 Thursday, March 10, 2011 11:18 AM