Dell POWEREDGE M1000E - Manual (Page 526)

526 Link Dependency Commands
Default Configuration
The default configuration for a group is down, i.e. the group members will
mirror the depended-on link status by going down when all depended-on
interfaces are down.
Command Mode
Link Dependency mode
User Guidelines
The action up command will cause the group members to be up when no
depended-on interfaces are up.
Example
console(config-depend-1)#action up
link-dependency group
Use the link-dependency group command to enter the link-dependency
mode to configure a link-dependency group
Syntax
link-dependency group GroupId
no link-dependency group GroupId
• GroupId — Link dependency group identifier. (Range: 1–72)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The preference of a group is to remain in the up state. A group will be in the
up state if any depends-on interface is up and will be in the down state only if
all depends-on interfaces are down.
2CSPC4.XModular-SWUM200.book Page 526 Thursday, March 10, 2011 11:18 AM