Dell POWEREDGE M1000E - Manual (Page 483)

IPv6 Access List Commands 483
• sequence seq-num — Order of access list relative to other access lists
already assigned to this interface and direction. (Range: 1–4294967295)
Default Configuration
This command has no default configuration.
Command Modes
Global Configuration mode
Interface Configuration (Ethernet, Port-channel, VLAN) mode
User Guidelines
This command specified in 'Interface Config' mode only affects a single
interface, whereas the 'Global Config' mode setting is applied to all interfaces.
Example
The following example attaches an IPv6 access control list to an interface.
console(config-if-1/0/1)#ipv6 traffic-filter DELL_IP6
in
show ipv6 access-lists
Use the show ipv6 access-lists command in User EXEC and Privileged EXEC
mode to display an IPv6 access list and all of the rules that are defined for the
IPv6 ACL. Use the [ name ] parameter to identify a specific IPv6 ACL to
display.
Syntax
show ipv6 access-lists [ name ]
Parameter Description
Parameter Description
name The name used to identify the IPv6 ACL.
Time Range Name Displays the name of the time-range if the IPv6 ACL rule has
referenced a time range.
2CSPC4.XModular-SWUM200.book Page 483 Thursday, March 10, 2011 11:18 AM