Dell POWEREDGE M1000E - Manual (Page 538)

538 LLDP Commands
Example
The following example displays how to enable the LLDP receive capability.
console(config-if-1/0/3)#lldp receive
lldp timers
Use the lldp timers command in Global Configuration mode to set the
timing parameters for local data transmission on ports enabled for LLDP. To
return any or all parameters to factory default, use the no form of this
command.
Syntax
lldp timers [interval transmit-interval] [hold hold-multiplier] [reinit reinit-
delay
]
no lldp timers [interval] [hold] [reinit]
• transmit-interval — The interval in seconds at which to transmit local data
LLDPDUs. (Range: 5–32768 seconds)
• hold-multiplier — Multiplier on the transmit interval used to set the TTL
in local data LLDPDUs. (Range: 2–10)
• reinit-delay — The delay in seconds before re-initialization. (Range: 1–10
seconds)
Default Configuration
The default transmit interval is 30 seconds.
The default hold-multiplier is 4.
The default delay before re-initialization is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 538 Thursday, March 10, 2011 11:18 AM