Dell POWEREDGE M1000E - Manual (Page 620)

620 QoS Commands
match ethertype
Use the match ethertype command in Class-Map Configuration mode to add
to the specified class definition a match condition based on the value of the
ethertype.
Syntax
match ethertype {keyword | 0x0600-0xffff }
• keyword — Specifies either a valid keyword or a valid hexadecimal number.
The supported keywords are appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, netbios, novell, pppoe, rarp. (Range:
0x0600–0xFFFF)
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add a match condition based on
ethertype.
console(config-classmap)#match ethertype arp
match ip6flowlbl
The match ip6flowlbl command adds to the specified class definition a
match condition based on the IPv6 flow label of a packet.
Syntax
match ip6flowlbl label
2CSPC4.XModular-SWUM200.book Page 620 Thursday, March 10, 2011 11:18 AM