Default configuration, Command mode, User guidelines – Dell POWEREDGE M1000E User Manual
Page 232: Example, Password (user exec), Syntax, Parameter description, Password
232
AAA Commands
Default Configuration
No password is specified.
Command Mode
Line Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies a password "mcmxxyyy" on a line.
console(config-line)# password mcmxxyyy
password
(User EXEC)
Use the password command in User EXEC mode to allow a currently logged
in user to change the password for only that user without having read/write
privileges. This command should be used after the password has aged. The
user is prompted to enter the old password and the new password.
NOTE:
For commands that configure password properties, see Password
Syntax
password
Parameter Description
This command does not require a parameter description.
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC mode
2CSPC4.XModular-SWUM200.book Page 232 Thursday, March 10, 2011 11:18 AM