Syntax, Default configuration, Command mode – Dell POWEREDGE M1000E User Manual
Page 1614: User guidelines, Example, Exit
Advertising
1610
User Interface Commands
end
Use the end command to get the CLI user control back to the privileged
execution mode or user execution mode.
Syntax
end
Default Configuration
This command has no default configuration.
Command Mode
All command modes
User Guidelines
No specific guidelines.
Example
console(config)#end
console#end
console>
exit
Use the exit command to go to the next lower command prompt or, in User
EXEC mode, to close an active terminal session by logging off the switch.
Syntax
exit
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 1610 Thursday, March 10, 2011 11:18 AM
Advertising