Dell POWEREDGE M1000E - Manual (Page 1431)

RMON Commands 1427
show rmon log
Use the show rmon log command in User EXEC mode to display the RMON
logging table.
Syntax
show rmon log [ event ]
• event — Event index. (Range: 1–65535)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following examples display the RMON logging table.
console> show rmon log
Maximum table size: 100
Jabbers The number of packets received during this sampling interval that were
longer than 1518 octets (excluding framing bits but including FCS
octets), and had either a bad Frame Check Sequence (FCS) with an
integral number of octets (FCS Error) or a bad FCS with a non-integral
number of octets (Alignment Error).
Dropped The total number of events in which packets were dropped by the probe
due to lack of resources during this sampling interval. This number is
not necessarily the number of packets dropped. It is just the number of
times this condition has been detected.
Collisions The best estimate of the total number of collisions on this Ethernet
segment during this sampling interval.
Field Description
2CSPC4.XModular-SWUM200.book Page 1427 Thursday, March 10, 2011 11:18 AM