Dell POWEREDGE M1000E - Manual (Page 1104)

1104 OSPF Commands
Syntax
ip ospf retransmit-interval seconds
no ip ospf retransmit-interval
• seconds — Number of seconds between link-state advertisement
retransmissions for adjacencies belonging to this router interface. This
value is also used when retransmitting database description and link-state
request packets. (Range: 0–3600 seconds)
Default Configuration
5 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
A value of 1 is the highest router priority. A value of 0 indicates that the
interface is not eligible to become the designated router on this network.
Example
The following example sets the OSPF retransmit Interval for VLAN 15 at 50
seconds.
console(config-if-vlan15)#ip ospf retransmit-interval
50
ip ospf transmit-delay
Use the ip ospf transmit-delay command in Interface Configuration mode to
set the OSPF Transit Delay for the specified interface. Use the no form of the
command to return the delay to the default value.
Syntax
ip ospf transmit-delay seconds
no ip ospf transmit-delay
2CSPC4.XModular-SWUM200.book Page 1104 Thursday, March 10, 2011 11:18 AM