Dell POWEREDGE M1000E - Manual (Page 983)

IPv6 Routing Commands 983
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables Ipv6 unicast datagram forwarding.
console(config)#ipv6 unicast-routing
console(config)#no ipv6 unicast-routing
ping ipv6
Use ping ipv6 command in Privileged EXEC mode to determine whether
another computer is on the network. To use the command, configure the
switch for network (in-band) connection. The source and target devices must
have the ping utility enabled and running on top of TCP/IP. The switch can
be pinged from any IP workstation with which the switch is connected
through the default VLAN (VLAN 1), as long as there is a physical path
between the switch and the workstation. The terminal interface sends three
pings to the target station.
Syntax
ping ipv6 { ip-address | hostname } [size size ]
• ipv6-address — Target IPv6 address to ping.
• hostname — Hostname to ping (contact). (Range: 1–158 characters). The
command allows spaces in the host name when specified in double quotes.
For example,
console(config)#ping ipv6 "host name"
• size — Size of the datagram. (Range: 48–2048 bytes)
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 983 Thursday, March 10, 2011 11:18 AM