Dell POWEREDGE M1000E - Manual (Page 440)

440 IGMP Snooping Commands
ip igmp snooping host-time-out
Use the ip igmp snooping host-time-out command in Interface
Configuration mode to configure the host-time-out. If an IGMP report for a
Multicast group is not received for a host time-out period from a specific port,
this port is deleted from the member list of that Multicast group. To reset to
the default host time-out, use the no form of this command.
Syntax
ip igmp snooping host-time-out time-out
no ip igmp snooping host-time-out
• time-out — Host timeout in seconds. (Range: 2- 3600)
Default Configuration
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
The timeout should be more than sum of response time and twice the query
interval.
Example
The following example configures the host timeout to 300 seconds.
console(config-if-1/0/1)#ip igmp snooping host-time-
out 300
ip igmp snooping leave-time-out
Use the ip igmp snooping leave-time-out command in Interface
Configuration mode to configure the leave-time-out. If an IGMP report for a
Multicast group is not received within the leave-time-out period after an
2CSPC4.XModular-SWUM200.book Page 440 Thursday, March 10, 2011 11:18 AM