Dell POWEREDGE M1000E - Manual (Page 940)

940 IPv6 PIM Commands
Example
console(if-vlan-10)#ipv6 pim
ipv6 pim sparse (Global config)
Use the ipv6 pim sparse command to administratively configure PIM sparse
mode for multicast routing. Use the no form of this command to disable PIM
sparse mode.
Syntax
ipv6 pim sparse
no ipv6 pim sparse
Default Configuration
IPv6 PIM is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router.
Example
console(config)#ipv6 pim sparse
ipv6 pim dense
Use the ipv6 pim dense command in Global configuration mode to
administratively configure PIM dense mode for IPv6 multicast routing. Use
the no form of this command to disable PIM dense mode.
Syntax
ipv6 pim dense
no ipv6 pim dense
2CSPC4.XModular-SWUM200.book Page 940 Thursday, March 10, 2011 11:18 AM