Dell POWEREDGE M1000E - Manual (Page 1173)

OSPFv3 Commands 1173
Syntax
ipv6 router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
Use the following command to enable OSPFv3.
console(config)#ipv6 router ospf
maximum-paths
Use the maximum-paths command in Router OSPFv3 Configuration mode
to set the number of paths that OSPF can report for a given destination.
Syntax
maximum-paths maxpaths
no maximum-paths
• maxpaths — Number of paths that can be reported. (Range: 1-2)
Default Configuration
2 is the default value for maxpaths .
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 1173 Thursday, March 10, 2011 11:18 AM