Dell POWEREDGE M1000E - Manual (Page 1179)

OSPFv3 Commands 1179
redistribute
Use the redistribute command in Router OSPFv3 Configuration mode to
configure the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers.
Syntax
redistribute {static | connected} [metric metric ] [metric-type {1 | 2}] [tag
tag ]
no redistribute {static | connected} [ metric ] [metric-type] [ tag ]
• metric — Metric value used for default routes. (Range: 0-16777214)
• tag — Tag. (Range: 0-4294967295)
Default Configuration
2 is the default value for metric-type, 0 for tag .
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the OSPFv3 protocol to allow
redistribution of routes from the specified source protocol/routers.
console(config)#ipv6 router ospf
console(config-rtr)#redistribute connected
router-id
Use the router-id command in Router OSPFv3 Configuration mode to set a
4-digit dotted-decimal number uniquely identifying the Router OSPF ID.
2CSPC4.XModular-SWUM200.book Page 1179 Thursday, March 10, 2011 11:18 AM