Dell POWEREDGE M1000E - Manual (Page 1027)

Multicast Commands 1027
ip pim join-prune-interval
The ip pim join-prune-interval command in Interface (VLAN)
Configuration mode to administratively configure the frequency of
join/prune messages on the specified interface. Use the no form of this
command to return the configuration to the default. This command
deprecates the ip pimsm message-interval and ip pimsm join-prune-interval
commands.
Syntax
ip pim join-prune-interval interval
no ip pim join-prune-interval
• interval — The number of seconds between successive join-prune
transmissions. Range: 0–18000 seconds. Default is 60.
Default Configuration
The default join/prune interval is 60 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only has an effect if sparse mode is enabled.
Example
console(if-vlan10)#ip pim join-prune-interval 30
ip pim register-rate-limit
Use the ip pim register-rate-limit command in Global Configuration mode
to set a limit on the maximum number of PIM register messages sent per
second for each (S,G) entry. Use the no form of this command to return the
limit to its default value (0). This command replaces the ip pimsm spt-
threshold command.
2CSPC4.XModular-SWUM200.book Page 1027 Thursday, March 10, 2011 11:18 AM