Parameter description, Default configuration, Command mode – Dell POWEREDGE M1000E User Manual
Page 944: User guidelines, Example, Ipv6 pim join-prune-interval, Syntax, Ipv6 pim join-prune, Interval
944
IPv6 PIM Commands
no ipv6 pim hello-interval
Parameter Description
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(if-vlan-10)#ipv6 pim hello-interval 20
ipv6 pim join-prune-interval
Use the ipv6 pim join-prune-interval command to administratively configure
the frequency of join/prune messages on the specified interface. Use the no
form of this command to return the join/prune interval to the default.
Syntax
ipv6 pim join-prune-interval
interval
no ipv6 pim join-prune-interval
Parameter Description
Parameter
Description
interval
The number of seconds between successive hello transmissions.
Range 0-18000. Default 30.
Parameter
Description
interval
The number of seconds between successive join-prune
transmissions. Range 0-18000 seconds. Default 60 seconds.
2CSPC4.XModular-SWUM200.book Page 944 Thursday, March 10, 2011 11:18 AM