Dell POWEREDGE M1000E - Manual (Page 693)

Spanning Tree Commands 693
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command configures the external cost. Since by default each switch is in
its own region, the external cost is considered in determining the spanning
tree of the network.
This command is also used to configure the rstp path cost.
Example
The following example configures the spanning-tree cost on 1/0/5 to 35000.
console(config)#interface gigabitethernet 1/0/5
console(config-if-1/0/5)#spanning-tree cost 35000
spanning-tree disable
Use the spanning-tree disable command in Interface Configuration mode to
disable spanning-tree on a specific port. To enable spanning-tree on a port,
use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
By default, all ports are enabled for spanning-tree.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 693 Thursday, March 10, 2011 11:18 AM